Command Modes

Command History

Usage Information

level-2

(OPTIONAL) Displays information about Level 2 IS-IS

 

neighbors.

detail

(OPTIONAL) Displays detailed information about neighbors.

interface

(OPTIONAL) Enter the following keywords and slot/port or

 

number information:

 

• For a 10-Gigabit Ethernet interface, enter the keyword

 

TenGigabitEthernet then the slot/port information.

 

• For a 40-Gigabit Ethernet interface, enter the keyword

 

fortyGigE then the slot/port information.

 

• For a port channel interface, enter the keywords port-

 

channel then a number.

 

• For a VLAN interface, enter the keyword vlan then a

 

number from 1 to 4094.

•EXEC

•EXEC Privilege

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

VersionDescription

9.7(0.0)

Added support for VRF. Introduced on the S6000-ON.

9.0.2.0Introduced on the S6000.

8.3.19.0Introduced on the S4820T.

8.3.12.0Introduced on the S4810.

8.3.11.1Introduced on the Z9000.

Use this command to confirm that the neighbor adjacencies are operating correctly. If you suspect that they are not, you can verify the specified area addresses of the routers by using the show isis neighbors command.

The following describes the show isis neighbors command shown in the following example.

Field

Description

System Id

The value that identifies a system in an area.

Interface

The interface, slot, and port in which the router was

 

discovered.

State

The value providing status about the adjacency state. The

 

range is Up and Init.

Intermediate System to Intermediate System (IS-IS)

903

Page 903
Image 903
Dell 9.7(0.0) manual Command Modes Command History Usage Information Level-2, Detail