Dell 9.7(0.0) PIM-Sparse Mode PIM-SM, IPv4 PIM-Sparse Mode Commands, Clear ip pim rp-mapping

38

PIM-Sparse Mode (PIM-SM)

The protocol-independent multicast (PIM) commands are supported by the Dell Networking operating software on the platform.

IPv4 PIM-Sparse Mode Commands

The following describes the IPv4 PIM-sparse mode (PIM-SM) commands.

clear ip pim rp-mapping

The bootstrap router (BSR) feature uses this command to remove all or particular rendezvous point (RP) advertisement.

S6000

Syntax

Parameters

Command Modes

Command History

clear ip pim [vrf vrf-name] rp-mapping [rp-address]

vrf vrf-name	(OPTIONAL) Enter the keyword vrf followed by the name of
	the VRF to configure this setting on that VRF.
	NOTE: Applies to specific VRF if input is provided, else
	applies to Default VRF.
rp-address	(OPTIONAL) Enter the RP address in dotted decimal format
	(A.B.C.D).
EXEC Privilege

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Version	Description
9.7(0.0)	Added support for VRF. Introduced on the S6000-ON.
9.5(0.0)	Introduced on the Z9500.

9.0.2.0Introduced on the S6000.

8.3.19.0Introduced on the S4820T.

PIM-Sparse Mode (PIM-SM) 1187