Defaults

Command Modes

Command History

Usage Information

Example

2

VRRP

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Version

Description

9.7(0.0)

Introduced on the S6000-ON.

9.5(0.0)

Introduced on the Z9000, S6000, S4820T, S4810, and MXL.

You can use the version both command to migrate from VRRPv2 to VRRPv3. When you set the VRRP protocol version to both, the switch sends only VRRPv3 advertisements but can receive either VRRPv2 or VRRPv3 packets. To migrate an IPv4 VRRP group from VRRPv2 to VRRPv3:

1.Set the switches with the lowest priority to “both”.

2.Set the switch with the highest priority to version to 3.

3.Set all the switches from both to version 3.

NOTE: Do not run VRRP version 2 and version 3 in the same group for an extended period of time.

Dell(conf-if-te-1/1-vrid-100)#version ?

2

VRRPv2

3

VRRPv3

both

Interoperable, send VRRPv3 receive

both

 

Dell(conf-if-te-1/1-vrid-100)#version 3

IPv6 VRRP Commands

The following are IPv6 VRRP commands.

clear counters vrrp ipv6

debug vrrp ipv6

show vrrp ipv6

vrrp-ipv6-group

The following commands apply to IPv4 and IPv6:

advertise-interval

description

1678

Virtual Router Redundancy Protocol (VRRP)

Page 1678
Image 1678
Dell 9.7(0.0) manual IPv6 Vrrp Commands