neighbor weight

Assign a weight to the neighbor connection, which is used to determine the best path.

S6000

Syntaxneighbor {ip-address peer-group-name} weight weight

Parameters

Defaults

Command Modes

Command History

Usage Information

To remove a weight value, use the no neighbor {ip-addresspeer- group-name} weight command.

ip-address

Enter the IP address of the peer router in dotted decimal

 

format.

peer-group-

Enter the name of the peer group to disable all routers within

name

the peer group.

weight

Enter a number as the weight. The range is from 0 to 65535.

 

The default is 0.

0

 

ROUTER BGP

 

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

VersionDescription

9.7(0.0)

Introduced on the S6000–ON.

9.0.2.0Introduced on the S6000.

8.3.19.0Introduced on the S4820T.

8.3.11.1Introduced on the Z9000.

8.3.7.0Introduced on the S4810.

7.8.1.0Introduced on the S-Series.

7.7.1.0Introduced on the C-Series.

In the Dell Networking OS best path selection process, the path with the highest weight value is preferred.

NOTE: In the Dell Networking OS best-path selection process, the path with the highest weight value is preferred.

If you configure the set weight command in a route map applied to this neighbor, the weight set in that command overrides the weight set in the neighbor weight command.

406

Border Gateway Protocol

Page 406
Image 406
Dell 9.7(0.0) manual Neighbor weight, Weight