show vrrp ipv6

View the IPv6 VRRP groups that are active. If no VRRP groups are active, the Dell Networking OS returns No Active VRRP group.

Syntax

Parameters

Command Modes

Command History

show vrrp ipv6 [vrid] [interface] [brief] [vrf vrf-name]

vrid

(OPTIONAL) Enter the virtual router identifier for the VRRP

 

group to view only that group. The range is from 1 to 255.

interface

Enter the following keywords and slot/port or number

 

information:

 

• For a 10-Gigabit Ethernet interface, enter the keyword

 

TenGigabitEthernet then the slot/port information.

 

• For a port channel interface, enter the keywords port-

 

channel then a number.

 

• For a VLAN interface, enter the keyword vlan then a

 

number from 1 to 4094.

brief

(OPTIONAL) Enter the keyword brief to view a table of

 

information on the VRRP groups.

vrf vrf-name

Enter the keyword vrf followed by the name of the VRF to

 

view IPv6 VRRP groups corresponding to that VRF.

•EXEC

•EXEC Privilege

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

VersionDescription

9.7(0.0)

Added support for VRF. Introduced on the S6000-ON.

8.3.19.0Introduced on the S4820T.

8.3.10.0Introduced on the S4810.

8.3.2.0Introduced on the E-Series TeraScale.

Usage

The following describes the show vrrp ipv6 command shown in the following

Information

example.

Virtual Router Redundancy Protocol (VRRP)

1681

Page 1681
Image 1681
Dell 9.7(0.0) manual Show vrrp ipv6 vrid interface brief vrf vrf-name