Dell 9.7(0.0) manual Set weight weight, Weight

Parameters

Defaults

Command Modes

Command History

Related Commands

tag-value	Enter a number as the tag. The range is from zero (0) to
	4294967295.
Not configured.
ROUTE-MAP

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

VersionDescription

9.7(0.0) Introduced on the S6000–ON.

9.0.2.0Introduced on the S6000.

8.3.19.0Introduced on the S4820T.

8.3.11.1Introduced on the Z9000.

8.3.7.0Introduced on the S4810.

8.1.1.0Introduced on the E-Series ExaScale.

7.6.1.0Introduced on the S-Series.

7.5.1.0Introduced on the C-Series.

pre-6.1.1.0 Introduced on the E-Series.

set automatic-tag — computes the tag value of the route.

set level — specifies the OSPF area for route redistribution.

set metric — specifies the metric value assigned to redistributed routes.

set metric-type — specifies the route type assigned to redistributed routes.

set weight

To add a non-RFC compliant attribute to the BGP route to assist with route selection, configure a filter.

Syntax

Parameters

set weight weight

To delete a weight specification, use the no set weight weight command.

weight	Enter a number as the weight used by the route meeting the
	route map specification. The range is from 0 to 65535. The
	default is router-originated = 32768 and all other routes = 0.
	When there are multiple routes to the same destination, the
	routes with a higher weight are preferred.

268 Access Control Lists (ACL)