Dell 9.7(0.0) manual Multiple Spanning Tree Mstp Mode, Openflow Instance Mode

To enter MONITOR SESSION mode:

1.Verify that you are logged in to CONFIGURATION mode.

2.Enter the monitor session command then the session ID. The prompt changes to include (conf- mon-sess-sessionID).

MULTIPLE SPANNING TREE (MSTP) Mode

To enable and configure MSTP, use MULTIPLE SPANNING TREE mode. For more information, refer to Multiple Spanning Tree Protocol (MSTP).

To enter MULTIPLE SPANNING TREE mode:

1.Verify that you are logged in to CONFIGURATION mode.

2.Enter the protocol spanning-tree mstp command. The prompt changes to include (conf- mstp).

You can return to CONFIGURATION mode by using the exit command.

OPENFLOW INSTANCE Mode

To enable and configure OpenFlow instances, use OPENFLOW INSTANCE mode. To enter OPENFLOW INSTANCE mode:

1.Verify that you are logged in to CONFIGURATION mode.

2.Enter the openflow of-instancecommand then the OpenFlow ID number of the instance you want to create or configure. The prompt changes to include (conf-of-instance of-id).

You can return to the CONFIGURATION mode by entering the exit command.

Per-VLAN SPANNING TREE (PVST+) Plus Mode

To enable and configure the Per-VLAN Spanning Tree (PVST+) protocol, use PVST+ mode. For more information, refer to Per-VLAN Spanning Tree Plus (PVST+).

NOTE: The protocol name is PVST+, but the plus sign is dropped at the CLI prompt.

To enter PVST+ mode:

1.Verify that you are logged in to CONFIGURATION mode.

2.Enter the protocol spanning-tree pvst command. The prompt changes to include (conf- pvst).

You can return to CONFIGURATION mode by using the exit command.

PORT-CHANNEL FAILOVER-GROUP Mode

To configure shared LAG state tracking, use PORT-CHANNEL FAILOVER-GROUP mode. For more information, refer to Port Channel Commands.

To enter PORT-CHANNEL FAILOVER-GROUP mode:

1.Verify that you are logged in to CONFIGURATION mode.

2.Enter the port-channelfailover-groupcommand. The prompt changes to include (conf-po- failover-grp).

You can return to CONFIGURATION mode by using the exit command.

54 CLI Basics