Usage Information

WARNING: The following message displays to confirm the command: All non-default configurations on the related member ports ports (<ports listed here>) will be removed. Do you want to continue (y/n)? If you enter “y”, all non-default configurations on any member ports of the current stack group is removed when the unit is rebooted.

vlan-stack access

Specify a Layer 2 port or port channel as an access port to the stackable VLAN network.

Syntax

vlan-stack access

 

To remove access port designation, use the no vlan-stack access command.

Defaults

Not configured.

Command

INTERFACE

Modes

 

Command

This guide is platform-specific. For command information about other platforms,

History

refer to the relevant Dell Networking OS Command Line Reference Guide.

 

The following is a list of the Dell Networking OS version history for this command.

Usage Information

VersionDescription

9.7(0.0)

Introduced on the S6000-ON.

9.0.2.0Introduced on the S6000.

8.3.19.0Introduced on the S4820T.

8.3.11.1Introduced on the Z9000.

8.3.7.0Introduced on the S4810.

8.2.1.0Introduced on the E-Series ExaScale.

7.6.1.0Introduced on the C-Series and S-Series.

E-Series original

Command

Prior to enabling this command, to place the interface in Layer 2 mode, enter the switchport command.

To remove the access port designation, remove the port (using the no member interface command) from all stackable VLAN enabled VLANs.

1600

VLAN Stacking

Page 1600
Image 1600
Dell 9.7(0.0) manual Vlan-stack access