VersionDescription

9.7(0.0)

Introduced on the S6000-ON.

9.0.2.0Introduced on the S6000.

8.3.19.0Instroduced on the S4820T.

8.3.11.1Introduced on the Z9000.

8.3.7.0Introduced on the S4810.

8.3.1.0Introduced on the C-Series and S-Series.

Usage

You must first enable DEI for this configuration to take effect.

Information

 

Related

dei enable – Make packets eligible for dropping based on their DEI value.

Commands

 

member

Assign a stackable VLAN access or trunk port to a VLAN. The VLAN must contain the vlan-stack compatible command in its configuration.

Syntax

member interface

Parameters

Defaults

Command Modes

Command History

To remove an interface from a Stackable VLAN, use the no member interface command.

interface

Enter the following keywords and slot/port or number

 

information:

 

• For a Port Channel interface, enter the keywords port-

 

channel then a number. The range is from 1 to 128.

 

• For a 10-Gigabit Ethernet interface, enter the keyword

 

TenGigabitEthernet then the slot/port information.

 

• For a 40-Gigabit Ethernet interface, enter the keyword

 

fortyGigE then the slot/port information.

Not configured.

 

CONF-IF-VLAN

 

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

1598

VLAN Stacking

Page 1598
Image 1598
Dell 9.7(0.0) manual Member, Usage