Dell 9.7(0.0) manual Interface null number, Number Enter zero 0 as the Null interface number

Usage Information

Example

Related Commands

VersionDescription

8.1.1.0Introduced on the E-Series ExaScale.

7.5.1.0Introduced on the C-Series.

6.4.1.0Introduced

You cannot delete a Management port.

The Management port is enabled by default (no shutdown). To assign an IP address to the Management port, use the ip address command.

If your system has two RPMs installed, use the show redundancy command to display which RPM is the Primary RPM.

Dell(conf)#interface managementethernet 0/0

Dell(conf-if-ma-0/0)#

management route — configures a static route that points to the Management interface or a forwarding router.

speed (Management interface) — clears the FIB entries on a specified line card.

interface null

Configure a Null interface on the switch.

S6000

Syntax

Parameters

Defaults

Command Modes

Command History

interface null number

number Enter zero (0) as the Null interface number.

Not configured; number = 0

CONFIGURATION

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

VersionDescription

9.7(0.0) Introduced on the S6000-ON.

9.0.2.0Introduced on the S6000.

8.3.19.0Introduced on the S4820T.

8.3.11.1Introduced on the Z9000.

Interfaces 679