Dell 9.7(0.0) manual DellVLTpeer1#show vlt statistics igmp-snoop, Unit-id 0

Example	Dell_VLTpeer1#show vlt statistics igmp-snoop
	VLT Igmp-Snooping Statistics
	-------------------------------
	IGMP Info Pkts sent:	4
	IGMP Info Pkts Rcvd:	1
	IGMP Reg Request sent:	1
	IGMP Reg Request rcvd:	2
	IGMP Reg Response sent:	1
	IGMP Reg Response rcvd:	1
	IGMP PDU Tunnel Pkt sent:5
	IGMP PDU Tunnel Pkt rcvd:10
	IGMP Tunnel PDUs sent:	10
	IGMP Tunnel PDUs rcvd:	19

unit-id

Explicitly configure the default unit ID of a VLT peer switch.

Syntax	unit-id [0 1]
Parameters	0 1	Configure the default unit ID of a VLT peer switch. Enter 0
		for the first peer or enter 1 for the second peer.

Defaults

Command Modes

Command History

Automatically assigned based on the MAC address of each VLT peer. The peer with the lower MAC address is assigned unit 0; the peer with the higher MAC address is assigned unit 1.

VLT DOMAIN

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Version	Description
9.7(0.0)	Introduced on the S6000-ON.
9.5(0.0)	Introduced on the Z9500.
9.2(0.0)	Introduced on the M I/O Aggregator. This command is
	supported in Programmable-Mux (PMUX) mode only.

9.0.2.0Introduced on the S6000.

9.0.0.0Introduced on the Z9000.

8.3.19.0Introduced on the S4820T.

8.3.8.0Introduced on the S4810.

Virtual Link Trunking (VLT) 1645