Dell 9.7(0.0) manual Version 2 3 both

Parameters

Defaults

Command Modes

Command History

vrrp-id Enter a number as the group ID. The range is from 1 to 255.

Not configured.

INTERFACE

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

VersionDescription

9.7(0.0) Introduced on the S6000-ON.

9.0.2.0Introduced on the S6000.

8.3.19.0Introduced on the S4820T.

8.3.11.1Introduced on the Z9000.

8.3.7.0Introduced on the S4810.

7.6.1.0Introduced on the S-Series.

7.5.1.0Introduced on the C-Series.

6.2.1.1Introduced on the E-Series.

Usage	The VRRP group only becomes active and sends VRRP packets when a virtual IP
Information	address is configured. When you delete the virtual address, the VRRP group stops
	sending VRRP packets.
Related	virtual-address — assigns up to 12 virtual IP addresses per VRRP group.
Command

version

Set VRRP protocol version for IPv4 group.

Syntax	version {2 3 both}
	To return to the default setting, use the no version command.
Parameters	2	Enter the 2 parameter to specify VRRP version 2 as defined
		by RFC 3768, Virtual Router Redundancy Protocol.
	3	Enter the 2 parameter to specify VRRP version 3 as defined in
		RFC 5798, Virtual Router Redundancy.
	both	Enter the both keyword for in-service migration from VRRP
		version 2 to VRRP version 3.

Virtual Router Redundancy Protocol (VRRP) 1677