VersionDescription

8.3.7.1Introduced on the S4810.

managed-config-flag

Set the managed address configuration flag.

Syntax

Parameters

Defaults

Command

Modes

Command

History

managed-config-flag {on off}

To clear the flag, use the no managed-config-flag {on off} command.

on

Enter the keyword on to set the managed-config-flag value

 

as ON.

off

Enter the keyword off to set the managed-config flag value

 

as OFF.

none

POLICY LIST CONFIGURATION

This guide is platform-specific. For command information about other platforms,

refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Version

Description

9.7(0.0)

Introduced on the S6000-ON.

9.7(0.0)

Introduced on the S4810, S4820T, S5000, S6000, and

 

Z9000 switches.

Related Commands

ipv6 nd ra-guard enable — Allows you to configure the RA guard related commands.

ipv6 nd raguard policy policy-name — Defines the router advertisement (RA) guard policy name and enter the RA guard policy configuration mode.

match ra

Enable verifying either of the configured source IPv6 address or prefix address or the source MAC address in the inspected messages. If this command is not configured, the verification process is bypassed.

Syntaxmatch ra {ipv6-access-list name ipv6-prefix-list name mac- access-list name}

To reset the access list, use the no match ra{ipv6-access-list ipv6- prefix-list mac-access-list}command.

1028

Neighbor Discovery Protocol (NDP)

Page 1028
Image 1028
Dell 9.7(0.0) manual Match ra, Managed-config-flag on off, Off