Command

CONFIGURATION

 

Modes

 

 

Command

Version

Description

History

 

 

 

9.7(0.0)

Introduced on the S6000-ON.

 

9.4(0.0)

Introduced on the S–Series.

Usage

Use this command to add the IPv4 catch-all route (0.0.0.0/0) in the LPM route

Information

forwarding table if it was deleted using the no ip unknown-unicastcommand

 

previously. This will be the default configuration after reload.

ipv4 unicast-host-route

Enable programming of IPv4 /32 route prefixes in L3 host table.

S6000

Syntax

Defaults

Command Modes

Command History

[no] ipv4 unicast-host-route

Disabled by default. By default, all the IPv4 route prefixes are installed only in the LPM table.

CONFIGURATION

Version

Description

9.7(0.0)

Introduced on the S6000-ON.

9.3(0.1)

Introduced on the S6000.

Usage

A warning message is displayed when you enter this command stating that this

Information

setting takes effect for existing routes only when IPv4 route prefixes are cleared

 

from the routing table (RTM). To disable this functionality, use no ipv4 unicast-

 

host-route command.

Example

Dell(conf)#ip unicast-host-route

 

Warning: Command will take effect for existing routes only

 

when IPv4

 

route prefixes are cleared from RTM

 

Dell(conf)#no ip unicast-host-route

IPv4 Routing

779

Page 779
Image 779
Dell 9.7(0.0) manual Ipv4 unicast-host-route