Dell 9.7(0.0) manual Host, Ipv6-address, Count, Datagram size, Timeout, Source, Tos, Df-bit

[sweep-max-size][sweep-interval] [ointerface (ip src-ipv4- address) interface]

Parameters	(OPTIONAL) Enter the host name of the devices to which
host
	you are testing connectivity.
ip-address	(OPTIONAL) Enter the IPv4 address of the device to which
	you are testing connectivity. The address must be in the
	dotted decimal format.
ipv6-address	(OPTIONAL) Enter the IPv6 address, in the x:x:x:x::x format,
	to which you are testing connectivity.
	NOTE: The :: notation specifies successive hexadecimal
	fields of zeros.
count	Enter the number of echo packets to be sent. The default is
	5.
	• number: from 1 to 2147483647
	• continuous: transmit echo request continuously
datagram size	Enter the ICMP datagram size. The range is from 36 to 15360
	bytes. The default is 100.
timeout	Enter the interval to wait for an echo reply before timing out.
	The range is from 0 to 3600 seconds. The default is 2
	seconds.
source	Enter the IPv4 or IPv6 source ip address or the source
	interface. For IPv6 addresses, you may enter global
	addresses only. Enter the IP address in A.B.C.D format.
	• For a 10-Gigabit Ethernet interface, enter the keyword
	TenGigabitEthernet then the slot/port information.
	• For a 40-Gigabit Ethernet interface, enter the keyword
	fortyGigE then the slot/port information.
	• For a port channel interface, enter the keywords port-
	channel then a number. The range is from 1 to 128.
	• For a VLAN interface, enter the keyword vlan then a
	number from 1 to 4094.
	• For a Tunnel interface, enter the keyword tunnel then a
	number from 1 to 16383.
tos	(IPv4 only) Enter the type of service required. The range is
	from 0 to 255. The default is 0.
df-bit	(IPv4 only) Enter Y or N for the “don't fragment” bit in IPv4
	header.
	• N: Do not set the “don't fragment” bit.
	• Y: Do set “don't fragment” bit
	Default is No.

118 Control and Monitoring