Dell 9.7(0.0) manual Enter the keyword interval followed by the number

Parameters

Defaults

Command Modes

Command History

Usage Information

Related Commands

interval	Enter the keyword interval followed by the number of
seconds	seconds to wait between FEFD control packets. Range is
	from 3 to 300 seconds. Default is 15 seconds.
normal	(OPTIONAL) Enter the keywords mode normal to change
	the link state to “unknown” when a far-end failure the
	software detects on that interface. When the interface is
	placed in “unknown” state, the software brings down the line
	protocol. The default is Normal mode.
aggressive	(OPTIONAL) Enter the keywords mode aggressive to
	change the link state to “error-disabled” when a far-end
	failure the software detects on that interface. When an
	interface is placed in “error-disabled” state, t enter the fefd
	reset command to reset the interface state.
Disabled.
CONFIGURATION

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

VersionDescription

9.7(0.0) Introduced on the S6000-ON.

9.0.2.0Introduced on the S6000.

8.3.19.0Introduced on the S4820T.

8.3.11.1Introduced on the Z9000.

8.3.12.0Introduced on the S4810.

Legacy E-Series command.

If you enter only the fefd-globalsyntax, the mode is normal and the default interval is 15 seconds.

If you disable FEFD globally (no fefd-global), the system does not remove the FEFD interface configuration.

•fefd — enables far-end failure detection.

•fefd-global interval — configures an interval between FEFD control packets.

•show fefd — shows the FEFD command output.

950 Layer 2