Command History

Usage Information

Related Commands

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

VersionDescription

9.7(0.0)

Introduced on the S6000-ON.

9.0.2.0Introduced on the S6000.

8.3.19.0Introduced on the S4820T.

8.3.11.1Introduced on the Z9000.

8.3.12.0Introduced on the S4810.

7.5.1.0Added support for IPv6 ISIS.

6.3.1.0Introduced.

To redistribute a default route (0.0.0.0/0), configure the default-information originate command.

Changing or disabling a keyword in this command does not affect the state of the other command keywords.

When an LSP with an internal metric is received, the Dell Networking OS considers the route cost while considering the advertised cost to reach the destination.

Redistributed routing information is filtered with the distribute-list out command to ensure that the routes are properly are passed to the receiving routing protocol.

How a metric value assigned to a redistributed route is advertised depends on how on the configuration of the metric-stylecommand. If the metric-stylecommand is set for Narrow or Transition mode and the metric value in the redistribute command is set to a number higher than 63, the metric value advertised in LSPs is 63. If the metric-stylecommand is set for Wide mode, the metric value in the redistribute command is advertised.

•default-information originate — generates a default route for the IS-IS domain.

•distribute-list out — suppresses networks from being advertised in updates. This command filters redistributed routing information.

Intermediate System to Intermediate System (IS-IS)

889

Page 889
Image 889
Dell 9.7(0.0) manual 889