Dell 9.7(0.0) manual Log-adjacency-changes, Ip ospf transmit-delay seconds

ip ospf transmit-delay

To send a link state update packet on the interface, set the estimated time elapsed.

S6000

Syntax

Parameters

ip ospf transmit-delay seconds

To return to the default value, use the no ip ospf transmit-delaycommand.

seconds	Enter the number of seconds as the interval between
	retransmission. The range is from 1 to 3600. The default is 1
	second.
	This value must be greater than the transmission and
	propagation delays for the interface.

Defaults

Command Modes

Command History

1 second

INTERFACE

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

VersionDescription

9.7(0.0) Introduced on the S6000-ON.

9.0.2.0Introduced on the S6000.

8.3.19.0Introduced on the S4820T.

8.3.11.1Introduced on the Z9000.

8.3.7.0Introduced on the S4810.

7.6.1.0Introduced on the S-Series.

7.5.1.0Introduced on the C-Series.

pre- 6.1.1.1 Introduced on the E-Series.

log-adjacency-changes

To send a Syslog message about changes in the OSPF adjacency state, set Dell Networking OS.

S6000

Syntaxlog-adjacency-changes

To disable the Syslog messages, use the no log-adjacency-changescommand.

Open Shortest Path First (OSPFv2 and OSPFv3) 1091