Dell 9.7(0.0) manual States if Icmp unreachable messages are sent, Unreachables

Usage Information

Example

Usage Information

VersionDescription

7.5.1.0Introduced on the C-Series.

pre-6.1.1.0 Introduced on the E-Series.

The following describes the show ip interface command shown in the following example.

Lines	Description
TenGigabitEthern	Displays the interface’s type, slot/port, and physical and line
et 1/1...	protocol status.
Internet address...	States whether an IP address is assigned to the interface. If
	an IP address is assigned, that address is displayed.
IP MTU is...	Displays IP MTU value.
Inbound access...	Displays the name of the configured incoming access list. If
	none is configured, the phrase “not set” is displayed.
Proxy ARP...	States whether proxy ARP is enabled on the interface.
Split horizon...	States whether split horizon for RIP is enabled on the
	interface.
Poison Reverse...	States whether poison for RIP is enabled on the interface.
ICMP redirects...	States if ICMP redirects are sent.
ICMP	States if ICMP unreachable messages are sent.
unreachables...

Dell#show ip int te 1/1

TenGigabitEthernet 1/1 is down, line protocol is down Internet address is not set

IP MTU is 1500 bytes

Inbound access list is not set Proxy ARP is enabled

Split Horizon is enabled Poison Reverse is disabled ICMP redirects are not sent ICMP unreachables are not sent

Dell#

The following describes the show ip interface brief command shown in the following example.

Fields	Description
Interface	Displays type of interface and the associated slot and port
	number.
IP-Address	Displays the IP address for the interface, if configured.
Ok?	Indicates if the hardware is functioning properly.

800 IPv4 Routing