Dell 9.7(0.0) manual Ip helper-address ip-address

Usage Information

Related Commands

VersionDescription

7.6.1.0Introduced on the S-Series.

7.5.1.0Introduced on the C-Series.

You can only configure one domain name with the ip domain-namecommand. To configure more than one domain name, configure the ip domain-listcommand up to six times.

To enable dynamic resolution of hosts, use the following steps:

•specify a domain name server with the ip name-servercommand

•enable DNS with the ip domain-lookupcommand

To view current bindings, use the show hosts command.

ip domain-list — configures additional names.

ip helper-address

Specify the address of a DHCP server so that DHCP broadcast messages can be forwarded when the DHCP server is not on the same subnet as the client.

S6000

Syntax

Parameters

Defaults

Command Modes

Command History

ip helper-address ip-address

To remove a DHCP server address, use the no ip helper-addresscommand.

ip-address Enter an IP address in dotted decimal format (A.B.C.D).

Not configured.

INTERFACE

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

VersionDescription

9.7(0.0) Introduced on the S6000-ON.

9.0.2.0Introduced on the S6000.

9.0.0.0Added support for IPv6.

IPv4 Routing 765