Dell 9.7(0.0) Ip pim rp-address, Command before creating the access-list, Group-address, Override

	Version	Description
	7.6.1.0	Introduced
Usage	The access name is an extended IP access list that denies PIM register packets to
Information	RP at the source DR based on the multicast and group addresses. Do not enter this
	command before creating the access-list.

ip pim rp-address

Configure a static PIM rendezvous point (RP) address for a group or access-list.

S6000

Syntax

Parameters

Defaults

Command Modes

Command History

ip pim [vrf vrf-name] rp-address address {group-address group-

address mask} [override]

To remove an RP address, use the no ip pim [vrf vrf-name]rp-addressaddress {group-addressgroup-address mask} [override] command.

vrf vrf-name	(OPTIONAL) Enter the keyword vrf followed by the name of
	the VRF.
	NOTE: Applies to specific VRF if input is provided, else
	applies to Default VRF.
address	Enter the RP address in dotted decimal format (A.B.C.D).
group-address	Enter the keywords group-addressthen a group-address
group-address	mask, in dotted decimal format (/xx), to assign that group
mask	address to the RP.
override	Enter the keyword override to override the BSR updates
	with static RP. The override takes effect immediately during
	enable/disable.
	NOTE: This option is applicable to multicast group range.
Not configured.
CONFIGURATION

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Version	Description
9.7(0.0)	Added support for VRF. Introduced on the S6000-ON.
9.5(0.0)	Introduced on the Z9500.

PIM-Sparse Mode (PIM-SM) 1197