max-age

To maintain configuration information before refreshing that information, set the time interval for the RSTP bridge.

Syntax

Parameters

max-age seconds

To return to the default values, use the no max-agecommand.

max-age

Enter a number of seconds the Dell Networking OS waits

 

before refreshing configuration information. The range is

 

from 6 to 40 seconds. The default is 20 seconds.

Defaults

20 seconds

Command

CONFIGURATION RSTP (conf-rstp)

Modes

 

Command

This guide is platform-specific. For command information about other platforms,

History

refer to the relevant Dell Networking OS Command Line Reference Guide.

 

The following is a list of the Dell Networking OS version history for this command.

Related Commands

VersionDescription

9.7(0.0)

Introduced on the S6000-ON.

9.0.2.0Introduced on the S6000.

8.3.19.0Introduced on the S4820T.

8.3.11.1Introduced on the Z9000.

8.3.7.0Introduced on the S4810.

7.6.1.0Introduced on the S-Series.

7.5.1.0Introduced on the C-Series.

6.2.1.1Introduced on the E-Series.

forward-delay — changes the wait time before RSTP transitions to the Forwarding state.

hello-time — changes the time interval between BPDUs.

protocol spanning-tree rstp

To configure RSTP, enter RSTP mode.

Syntax

protocol spanning-tree rstp

 

To exit RSTP mode, use the exit command.

1352

Rapid Spanning Tree Protocol (RSTP)

Page 1352
Image 1352
Dell 9.7(0.0) manual Protocol spanning-tree rstp