Dell 9.7(0.0) manual Show ip route summary, Show ip route vrf vrf-name summary, Active Routes

show ip route summary

View a table summarizing the IP routes in the switch.

S6000

Syntax	show ip route vrf vrf-namesummary
Parameters	vrf vrf-name	Enter the keyword vrf followed by the name of the VRF to

view information on the IP routes corresponding to that VRF.

Command Modes

Command History

Usage Information

•EXEC

•EXEC Privilege

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Version	Description
9.7(0.0)	Introduced on the S6000-ON.
9.4(0.0)	Added support for VRF.

9.0.2.0Introduced on the S6000.

8.3.19.0Introduced on the S4820T.

8.3.11.1Introduced on the Z9000.

8.3.7.0Introduced on the S4810.

8.1.1.0Introduced on the E-Series ExaScale.

7.6.1.0Introduced on the S-Series.

7.5.1.0Introduced on the C-Series.

pre-6.1.1.0 Introduced on the E-Series.

The following describes the show ip route summary shown in the following example.

Column Heading	Description
Route Source	Identifies how the route is configured in Dell Networking
	OS.
Active Routes	Identifies the best route if a route is learned from two
	protocol sources.
Non-active	Identifies the back-up routes when a route is learned by two
Routes	different protocols. If the best route or active route goes
	down, the non-active route becomes the best route.

IPv4 Routing 811