TRACTION DRIVE CABLE ADJUSTMENT
1. Runthe engine untilthe fuel tank is
emptyand the engine stops.
2. Standthe snow thrower up onthe
front end ofthe auger housing.
3. Loosenthe bolts on each sideof
the bottom panel (see Figure 34).
Bolt BottomPanel
Figure34
4. Removethe bottom panel.
5. Disconnect the "Z" tiffing from the
drive lever (see Figure32).
6, Slidethe cable boot off the cable
adjustment bracket (see
Figure35),
7. Pushthe bottom of the traction
drive cable through the cable ad-
justment bracket untilthe =Z"
hook can be removed.
8. Remove the uZ" hook from the
cable adjustment bracket. Move
the "Z" hook downto the next ad-
jus_nent hole.
9. Pullthe traction drive cable up
through the cable adjustment
bracket.
10. Put the cable boot over the cable
adjustment bracket.
11. Install the =Z" hook to the traction
drive lever (see Rgure 32).
12.To check the adjustment, depress
the drivelever and check the length
of one of the drive springs. In cor-
rectadjustment, the lengthof the
drive spring is:
minimum3" (76 ram.)
maximum 3-3/8m(85 ram.)
(see Figure 36).
Traction /
CableBOot/F_
CableAdjustment./_ "Z"Hook
Bracket Figure35
F-O410111L 2B