NOTE: Ifthe cables have become dis-
connected, connect cables as shown in
Figure 7.
TractionDriveCable Auger DriveCable
Figure7
HOW TO ASSEMBLE THE CHUTE DEFLECTOR
1. Remove the carriage boll See
Figure 8.
2. Raise the chute deflector into op-
erating position.
3. Fasten chute deflector toflange
with carriage bolt. Make sure to
install with head of carriage bolt on
the insideof the flange.
4. Fasten withwasher and Iocknut.
5. "RghtenIooknut securely.
NOTE: Make sure all cerriage
bolts in flange are tight. DO NOT
OVERTIGHTEN.
De_ector

jT=z=._._Jj...... __

Nut /-- _, Operatng_l

IIIii I_o_.oo-I

/k. ,--.or
Figure8
HOW TO SET THE SKID HEIGHT
Yoursnow thrower is equipped with
height adjust skids on the outside of the
auger housing. Toadjust the skid
heightfor different conditions, see To
Adjust Skid Height paragraph In the
Service And AdJust_nent section.
HOW TO SET THE LENGTH OF THE CABLES
The cables were adjusted atthe factory
and no adjustments should be neces-
sary. However, al_erthe handles are put
in the operating position, the cables can
be too tight or too loose. If an adjust-
ment is necessary, see =How ToCheck
And AdjustThe Cables" in the Service
And Adjustment section.
F-O410111L 9