11. Remove the three fasteners that
hold the frl_ion wheel tothe hub
(see Figure 43).
12.Remove the friction wheelfrom the
hub. Slipthe friction wheel offthe
hex shaft.
13.Assemble the new frletlon wheel
onto hub with the fasteners re-
moved earlier.
14.Install thehex shaft and bearings
withthe four bolts removed eadier
(see Figure 44).
Make sure the washers are prop-
erly Installed in the original posi-
tion. Also, make sure the two
washers are properly aligned
w/th the actuator arms.
15.Make surethe hex shaft turns free-
ly.
16.Install the left wheel, axle, and
drive sprocket with the fasteners
removed earlier, install the chain
onto the drive sprocket (see
Figure 41).
17.Check the adjustmentof the friction
wheel. See =How To Adjust The
FrictionWheel" in thissection.
18.Make sum the frictionwheel end the
disc drive plate are free fromgrease
oroil.
19.Install the bottom panel (see
Figure40).
20."13ghtenthe bolts on each side of
the bottom panel.
21. Installthe right wheel to the axle
withthe fasteners removed earlier.
22. Connect the sparkplug wire.
Friction
Fasteners Hub Wheel
Fasteners
Figure43
ActuatorArms
Beadngs \
\
Washer

/

Washer
,/ Washer
Figure 44
F..0410111L 31