Dell 9.7(0.0) manual Protocol spanning-tree stp-id

Related Commands

VersionDescription

6.2.1.1Introduced on the E-Series.

forward-delay — changes the wait time before STP transitions to the Forwarding state.

hello-time — changes the time interval between BPDUs.

protocol spanning-tree

To enable and configure the spanning tree group, enter SPANNING TREE mode.

Syntax protocol spanning-tree stp-id

Parameters

Defaults

Command Modes

Command History

Usage Information

To disable the Spanning Tree group, use the no protocol spanning-treestp-idcommand.

stp-id	Enter zero (0). Dell Networking OS supports one spanning
	tree group, group 0.
Not configured.
CONFIGURATION

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

VersionDescription

9.7(0.0) Introduced on the S6000-ON.

9.0.2.0Introduced on the S6000.

8.3.19.0Introduced on the S4820T.

8.3.11.1Introduced on the Z9000.

8.3.7.0Introduced on the S4810.

7.7.1.0Introduced on the S-Series.

7.5.1.0Introduced on the C-Series.

6.2.1.1Introduced on the E-Series.

STP is not enabled when you enter SPANNING TREE mode. To enable STP globally on the switch, use the no disable command from SPANNING TREE mode.

1558 Spanning Tree Protocol (STP)