Dell 9.7(0.0) manual Track interface line-protocol

Defaults

Command Modes

Command History

Usage Information

Related Commands

none

CONFIGURATION

VersionDescription

9.7(0.0) Introduced on the S6000-ON.

8.3.12.0Introduced on the S4810.

8.4.1.0Introduced.

Use this command to create an object that tracks the routing state of an IPv4 Layer

2 interface:

•The status of the IPv4 interface is UP only if the Layer 2 status of the interface is UP and the interface has a valid IP address.

•The Layer 3 status of an IPv4 interface goes DOWN when its Layer 2 status goes down (for a Layer 3 VLAN, all VLAN ports must be down) or the IP address is removed from the routing table.

•show track – displays information about tracked objects, including configuration, current state, and clients which track the object.

•track interface line-protocol – configures object tracking on the line-protocol state of a Layer 2 interface.

track interface line-protocol

Configure object tracking on the line-protocol state of a Layer 2 interface.

Syntaxtrack object-idinterface interface line-protocol

To return to the default setting, use the no track object-idcommand.

Parameters	Enter the ID number of the tracked object. The range is 1 to
object-id
	500.
interface	Enter one of the following values:
	• For a 10-Gigabit Ethernet interface, enter the keyword
	TenGigabitEthernet then the slot/port information.
	• For a 40-Gigabit Ethernet interface, enter the keyword
	fortyGigE then the slot/port information.
	• For a Loopback interface, enter the keyword loopback
	then a number from 0 to 16383.
	• For a port channel interface, enter the keywords port-
	channel then a number.
	• For a VLAN interface, enter the keyword vlan then a
	number from 1 to 4094.

Object Tracking 1047