Dell 9.7(0.0) - page 940

Parameters interface Enter the following keywords and slot/port or number

information:

• For a port channel interface, enter the keywords port-

channel then a number. The range is from 1 to 128.

• For a 10-Gigabit Ethernet interface, enter the keyword

TenGigabitEthernet then the slot/port information.

• For a 40-Gigabit Ethernet interface, enter the keyword

fortyGigE then the slot/port information.

Defaults All interfaces in Layer 2 mode are untagged.

Command

Modes

INTERFACE VLAN

Command

History This guide is platform-specific. For command information about other platforms,

refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Version Description

9.7(0.0) Introduced on the S6000-ON.

9.0.2.0 Introduced on the S6000.

8.3.19.0 Introduced on the S4820T.

8.3.11.1 Introduced on the Z9000.

8.5.1.0 Added support for 4-port 40G line cards on ExaScale.

8.3.7.0 Introduced on the S4810.

7.6.1.0 Introduced on the S-Series.

7.5.1.0 Introduced on the C-Series.

pre-6.2.1.1 Introduced on the E-Series.

Usage

Information When you use the no tagged command, the interface is automatically placed in

the Default VLAN as an untagged interface unless the interface is a member of

another VLAN. If the interface belongs to several VLANs, remove it from all VLANs

to change it to an untagged interface.

Tagged interfaces can belong to multiple VLANs, while untagged interfaces can

only belong to one VLAN at a time.

Commands interface vlan — configures a VLAN.

untagged — specifies which interfaces in a VLAN are untagged.

940 Layer 2