Defaults

Parameters

Command Modes

Command History

Usage Information

Related Commands

Disabled.

 

vrf vrf-name

(OPTIONAL) Enter the keyword vrf followed by the name of

 

the VRF to enable IP multicast forwarding on that VRF.

CONFIGURATION

 

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

VersionDescription

9.7(0.0)

Added support for VRF. Introduced on the S6000-ON.

9.0.2.0Introduced on the S6000.

8.3.19.0Introduced on the S4820T.

8.3.11.1Introduced on the Z9000.

8.3.7.1Introduced on the S4810.

E-Series legacy command

After you enable multicast, you can enable IGMP and PIM on an interface. In INTERFACE mode, enter the ip pim sparse-modecommand to enable IGMP and PIM on the interface.

ip pim sparse-mode — enables IGMP and PIM on an interface.

show ip mroute

View the multicast routing table.

S6000

Syntax

Parameters

show ip mroute [vrf vrf-name] [static group-address[source- address] count snooping [vlan vlan-idIntroduced on the S6000-ON.] [group-address[source-address]] summary vlt [group-address[source-address] count]

vrf vrf-name

(OPTIONAL) Enter the keyword vrf followed by the name of

 

the VRF to configure this setting on that VRF.

 

NOTE: Applies to specific VRF if input is provided, else

 

applies to Default VRF.

static

(OPTIONAL) Enter the keyword static to view static

 

multicast routes.

1016

Multicast

Page 1016
Image 1016
Dell 9.7(0.0) manual Show ip mroute, Syntax Parameters