Dell 9.7(0.0) manual Vrrp group and is also used for VRF routing

• When VRF microcode is loaded in CAM, the VRID for a VRRP group is equal to

	16 times the vrrp-group or vrrp-ipv6-group vrid number plus the ip
	vrf vrf-idnumber. For example, if VRF microcode is loaded and VRRP group
	10 is configured in VRF 2, the VRID used for the VRRP group is (16 x 10) + 2, or
	162. This VRID value is used in the lowest byte of the virtual MAC address of the
	VRRP group and is also used for VRF routing.
	NOTE: Configure the same VRID on neighboring routers (Dell Networking or
	non-Dell Networking) in the same VRRP group in order for all routers to
	interoperate.
Related	virtual-address — assigns up to 12 virtual IP addresses per VRRP group.
Commands

1684 Virtual Router Redundancy Protocol (VRRP)