Dell 9.7(0.0) manual Fefd interval seconds

Command History

Usage Information

Related Commands

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

VersionDescription

9.7(0.0) Introduced on the S6000-ON.

8.3.19.0Introduced on the S4820T.

8.3.11.1Introduced on the Z9000.

8.3.7.0Introduced on the S4810.

Legacy E-Series command.

When you enter no fefd for an interface and fefd-global, FEFD is enabled on the interface because the no fefd command is not retained in the configuration file. To keep the interface FEFD disabled when the global configuration changes, use the fefd reset command.

•fefd reset — enables FEFD globally on the system.

•fefd mode — changes FEFD mode on an interface.

fefd interval

Set an interval between control packets.

Syntax

Parameters

Defaults

Command Modes

Command History

fefd interval seconds

To return to the default value, use the no fefd interval command.

seconds	Enter a number as the time between FEFD control packets.
	The range is from 3 to 300 seconds. The default is 15
	seconds.
15 seconds
INTERFACE

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

946 Layer 2