Dell 9.7(0.0) manual Show lldp neighbors interface detail

Modified output of detail parameter to display remote management IP addresses.

When you enter the LLDP protocol in the Interface context, it overrides global configurations. When you execute the no protocol lldp from INTERFACE mode, interfaces begin to inherit the configuration from global LLDP CONFIGURATION mode.

show lldp neighbors

Display LLDP neighbor information for all interfaces or a specified interface.

S6000

Syntax

Parameters

Defaults

Command Modes

Command History

show lldp neighbors [interface] [detail]

interface	(OPTIONAL) Enter the following keywords and slot/port or
	number information:
	• For a 10-Gigabit Ethernet interface, enter the keyword
	TenGigabitEthernet then the slot/port information.
	• For a 40-Gigabit Ethernet interface, enter the keyword
	fortyGigE then the slot/port information.
detail	(OPTIONAL) Enter the keyword detail to display all the TLV
	information, remote management IP addresses, timers, and
	LLDP tx and rx counters.
none
EXEC Privilege

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Version	Description
9.7(0.0)	Introduced on the S6000-ON.

9.0.2.0Introduced on the S6000.

9.1.(0.0)

8.3.19.0Introduced on the S4820T.

8.3.11.1Introduced on the Z9000.

8.5.1.0Added support for 4-port 40G line cards on ExaScale.

8.3.7.0Introduced on the S4810.

7.7.1.0Introduced on the S-Series.

7.6.1.0Introduced on the C-Series.

Link Layer Discovery Protocol (LLDP) 963