27

Link Aggregation Control Protocol (LACP)

This chapter contains commands for Dell Networks’s implementation of the link aggregation control protocol (LACP) for creating dynamic link aggregation groups (LAGs) — known as “port-channels” in the Dell Networking operating software. The LACP commands in this chapter are supported by Dell Networking OS on the S6000 platform.

NOTE: For static LAG commands, refer to Port Channel Commands in the Interfaces chapter), based on the standards specified in the IEEE 802.3 Carrier sense multiple access with collision detection (CSMA/CD) access method and physical layer specifications.

clear lacp counters

Clear port channel counters.

S6000

Syntax

clear lacp port-channel-number counters

Parameters

port-channel-Enter a port-channel number. The range is from 1 to 128. number

Defaults

Command Modes

Command History

Without a Port Channel specified, the command clears all Port Channel counters.

EXEC

EXEC Privilege

This guide is platform-specific. For command information about other platforms,

refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

VersionDescription

9.7(0.0)

Introduced on the S6000–ON.

9.0.2.0Introduced on the S6000.

8.3.19.0Introduced on the S4820T.

8.3.11.1Introduced on the Z9000.

8.3.7.0Introduced on the S4810.

910

Link Aggregation Control Protocol (LACP)

Page 910
Image 910
Dell 9.7(0.0) manual Link Aggregation Control Protocol Lacp, Clear lacp counters