
AUTO-CLOSE TIMER
PROGRAMMING
This function is not available for the North American market.
The factory set
In order to confirm the operation of the Auto- Close timer first set DIP switch No. 4 to ON. Then press the case push button to open the door. The door will open and
To change the
1.Close the door.
2.Set DIP switch No. 4 to the ON position.
3.Press and hold the program button.
4.Release the button after the SECOND flash or beep.
5.Press the OPEN push button.
6.After the door has fully opened and after the required delay press the CLOSE push button. This new delay will now be stored into the memory and retained during any power interruptions.
A sequence of 6 flashes and beeps follow to prompt you to decide if you want the door to
It is preferable that the door should
If the door is required to
If the CLOSE button is not pressed during the flashes and beeps the controller will default to stay open after an obstruction
If it is required to change the programmed delay then repeat the programming sequence.
If a Zap Radio Remote Control system is fitted and the
Whilst the door is open, the close delay is reset each time the Zap transmitter is operated and each time a safety circuit or
ZAP 800-R CONTROLLER WIRING
ACCESSORY RADIO – PULSE OPERATION
()
855$
,%$!$
%67
123 $4 53
)+ !
)!$%, -
. &$! $/ $0
18