
|
| FAULT FINDING GUIDE |
|
|
|
FAULT |
| REASON & REMEDY |
1. The door stops just |
| A. The door movement is stiff due to the door running tight against |
after it has started in |
| the door frame in the fully closed position. In which case adjust the |
the open direction. |
| position of the roller wheel supports to ease the pressure of the |
|
| door against the frame. |
|
| B. The door is badly out of balance. In which case |
|
| counterbalance springs. |
|
| C. The door is near the maximum weight for the operator and the |
|
| Maximum Motor Current adjuster is set too low. In which case turn |
|
| the adjuster a further 20 degrees |
|
|
|
2. The closing door |
| A. There is an abnormality in the track, which is causing the roller |
stops and reopens |
| wheels to jump. This may be due to a misalignment of track |
before it contacts the |
| sections or a deformity of a damaged section of track. In which |
ground. |
| case correct the track problem and ensure the door will run |
|
| smoothly by hand movement with the |
|
| B. The Close Sensitivity adjuster is set too fine. In which case turn the |
|
| adjuster |
|
|
|
22