Zap 815-RL installation instructions Fitting The Motor Cover Kit

be strapped to the Super-Drive Bowden cable with cable ties to allow both cables to seat neatly in the slot in the bottom of the Motor Cover. (Pic 20)

Pic 20

Do not cut or shorten the Motor Cable. Ensure that any unused cable is coiled and secured away from any moving parts, using the cable ties provided.

NOTE THAT ALL TERMINALS ARE PLUG-IN FOR EASE OF WIRING and that all terminal functions are labelled on the panel.

FITTING THE MOTOR COVER KIT

The kit includes a front and back cover section. The cover front has two clips, which clip over the motor barrel.

Position the cover front with the clips resting on the motor barrel. Then firmly push the cover with a hand over the cover clip positions to ensure that the clips are seated in position over the motor barrel. (Pic 21)

Pic 21

The upper two pegs in the top edge of the cover back are next located in the two holes in the top edge of the cover front. (Pic 22).

Pic 22

Seat the cover back in the recess of the front cover and fit the 2 bottom screws and at least one of the side screws provided. (Pic 23 overleaf)

8