Dell 9.7(0.0) manual Interface loopback, Usage Information Example Related Commands

Usage Information

Example

Related Commands

The interface group command will create all the non-existent VLANs specified in the range. On successful command execution, the CLI switches to the interface group context.

The configuration commands inside the group context will be the similar to that of the existing range command.

Note: For release 9.4(0.0), the group command is supported only for VLANs and physical interfaces.

Dell(conf)#interface group ?

fortyGigE	FortyGigabit Ethernet interface
gigabitethernet	GigabitEthernet interface IEEE 802.3z
tengigabitethernet	TenGigabit Ethernet interface
vlan	VLAN keyword

Dell(conf)# interface group vlan 1 - 2 , tengigabitethernet 1/10

Dell(conf-if-group-vl-1-2,te-1/10)# no shutdown Dell(conf-if-group-vl-1-2,te-1/10)# end

interface range — Configures a range of interfaces.

interface vlan — Configures a VLAN.

interface loopback

Configure a Loopback interface.

S6000

Syntax interface loopback number

Parameters

Defaults

Command Modes

Command History

To remove a loopback interface, use the no interface loopback number command.

number	Enter a number as the interface number. The range is from 0
	to 16383.
Not configured.
CONFIGURATION

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Version 9.0.2.0	Introduced on the S6000.
Version	Introduced on the S4820T.
8.3.19.0

Interfaces 677