Command Modes

Command History

Usage Information

Related Commands

EXEC Privilege

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

VersionDescription

9.7(0.0)

Introduced on the S6000-ON.

9.0.2.0Introduced on the S6000.

8.3.19.0Introduced on the S4810.

8.3.11.1Introduced on the Z9000.

8.3.7.0Introduced on the S4810.

7.7.1.0Introduced on the S-Series.

You cannot enter this command on a Master or Standby unit.

The system reboots when the off-line diagnostics complete. This reboot is an automatic process. A warning message appears when the offline stack-unitcommand is implemented.

Warning - Diagnostic execution will cause stack-unit to reboot after completion of diags.

Proceed with Offline-Diags [confirm yes/no]:y

show environment (S-Series) — views the S-Series system component status (for example, temperature, voltage).

Hardware Commands

These commands display information from a hardware sub-component or ASIC.

clear hardware stack-unit

Clear statistics from selected hardware components.

Syntaxclear hardware stack-unit id {counters unit 0–0counters cpu data-plane statistics cpu i2c statistics cpu party-bus statistics cpu sata-interface statistics stack-port 0–127}

Parameters

stack-unit id

Enter the keywords stack-unitthen a number to select a

 

 

 

particular stack member and then enter one of the following

526

Debugging and Diagnostics

Page 526
Image 526
Dell 9.7(0.0) manual Hardware Commands, Clear hardware stack-unit