Usage
Information After entering the boot change command and selecting the parameters, press
Enter. The software prompts you to enter the following:
• The boot device (flash, ftp, tftp, or usbflash), image file name, IP address of the
server containing the image, username, and password (only for ftp).
Note When you enter a new parameter that extends beyond 80 characters, you
cannot use the Backspace key to correct any mistakes. If you make a mistake, you
must re-enter the parameter.
Note: You must set the IP address of the designated download port before you
execute this command. Otherwise, an second statement message alerts you that
the configuration cannot proceed.
shows the first field after you enter boot change primary. At this point:
• Press Enter to accept the information already configured, or
• Change that information. To do so, press the . (period) key and enter new
information. After you enter the information, press Enter.
Example BOOT_USER # boot change primary
boot device : ftp
shows the completed command:
BOOT_USER # boot change primary
'.' = clear field; '-' = go to previous field
boot device : ftp
file name : tt/latestlabel
Server IP address : 10.16.1.200
username : amsterdam
password : ******
BOOT_USER #
To view the current boot configuration, use the show bootvar command.
Related
Commands
boot_zero — Remove the primary, secondary, or default boot image configuration.
show_bootvar — Display boot configuration information.
boot message
Use this command to enable/disable boot logs during reload.
S6000
Syntax boot message on | off
Parameters on Enter the keyword on to turn on boot logs during reload.
324 Boot Command Line Interface