Dell 9.7(0.0) manual Set metric-type internal external type-1 type-2, Type-1, Type-2

set tag — specifies the tag assigned to redistributed routes.

set metric-type

To assign a new route type for routes redistributed to OSPF, configure a filter.

Syntax

Parameters

Defaults

Command Modes

Command History

set metric-type {internal external type-1 type-2}

To delete a setting, use the no set metric-typecommand.

internal	Enter the keyword internal to assign the Interior Gateway
	Protocol metric of the next hop as the route’s BGP
	MULTI_EXIT_DES (MED) value.
external	Enter the keyword external to assign the IS-IS external
	metric.
type-1	Enter the keyword type-1to assign the OSPF Type 1 metric.
type-2	Enter the keyword type-2to assign the OSPF Type 2 metric.
Not configured.
ROUTE-MAP

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Version	Description
9.7(0.0)	Introduced on the S6000–ON.
9.0.2.0	Introduced on the S6000.
8.3.19.0	Introduced on the S4820T.
8.3.11.1	Introduced on the Z9000.
8.3.7.0	Introduced on the S4810.
8.3.1.0	Implemented the keyword internal.
8.1.1.0	Introduced on the E-Series ExaScale.
7.6.1.0	Introduced on the S-Series.
7.5.1.0	Introduced on the C-Series.
pre-6.1.1.0	Introduced on the E-Series.

Related	set automatic-tag — computes the tag value of the route.
Commands
	set level — specifies the OSPF area for route redistribution.

Access Control Lists (ACL) 265