Dell 9.7(0.0) manual Match ip access-group, Access-group, Set-ip-dscp, Set-color value

match ip access-group

Configure match criteria for a class map, based on the access control list (ACL).

NOTE: IPv6 class-maps and IP-any class-maps do not match. This condition is true for IPv6 and IP- any class-maps on both ACLs as well as VLANs.

S6000

Syntaxmatch ip access-group access-group-name[set-ip-dscp value set-color value]

Parameters

Defaults

Command Modes

Command History

Usage Information

To remove ACL match criteria from a class map, use the no match ip access- group access-group-name[set-ip-dscpvalue set-colorvalue] command.

access-group-	Enter the ACL name whose contents are used as the match
name	criteria in determining if packets belong to the class the
	class-map specifies.
set-ip-dscp	(OPTIONAL) Enter the keywords set-ip-dscpthen the IP
value	DSCP value. The matched traffic is marked with the DSCP
	value. The range is from 0 to 63.
set-color value	(Optional) Enter the keyword set-color followed by a color
	value. Traffic that fulfills the match criteria is marked with the
	color value that you specify. The default value is Yellow.

none

CLASS-MAP CONFIGURATION (config-class-map)

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

VersionDescription

9.7(0.0) Introduced on the S6000-ON.

9.0.2.0Introduced on the S6000.

8.3.19.0Introduced on the S4820T.

8.3.11.1Introduced on the Z9000.

8.3.11.1Introduced on the Z9000.

8.3.7.0Introduced on the S4810.

To access this command, enter the class-mapcommand. After the class map is identified, you can configure the match criteria. For class-map match-any, a maximum of five ACL match criteria are allowed. For class-mapmatch-all, only one ACL match criteria is allowed.

Quality of Service (QoS) 1259