VersionDescription

8.3.11.1Introduced on the Z9000.

8.3.7.0Introduced on the S4810.

7.6.1.0Introduced on the S-Series.

7.5.1.0Introduced on the C-Series.

E-Series legacy command

snmp-server trap-source

Configure a specific interface as the source for SNMP traffic.

Syntax

snmp-server trap-source interface

 

To disable sending traps out a specific interface, use the no snmp trap-source

 

command.

Parameters

Enter the following keywords and slot/port or number

interface

 

information:

Defaults

Command Modes

Command History

•For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then the slot/port information.

•For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the slot/port information.

•For a Loopback interface, enter the keyword loopback then a number from 0 to 16383.

•For a port channel interface, enter the keywords port- channel then a number.

•For a Null interface, enter the keyword null then the Null interface number.

•For a VLAN interface, enter the keyword vlan then a number from 1 to 4094.

The IP address assigned to the management interface is the default.

CONFIGURATION

This guide is platform-specific. For command information about other platforms,

refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

VersionDescription

9.7(0.0)

Introduced on the S6000-ON.

9.0.2.0Introduced on the S6000.

Simple Network Management Protocol (SNMP) and Syslog

1493

Page 1493
Image 1493
Dell 9.7(0.0) manual Snmp-server trap-source interface