Dell 9.7(0.0) manual IPv4 Object Tracking Commands, Debug track, Object-id

35

Object Tracking

Object Tracking supports IPv4 and IPv6, and is available on the Dell Networking, C-Series, E-Series, S- Series, and S4810 platforms.

Object tracking allows you to define objects of interest, monitor their state, and report to a client when a change in an object’s state occurs. The following tracked objects are supported:

•Link status of Layer 2 interfaces

•Routing status of Layer 3 interfaces (IPv4 and IPv6)

•Reachability of IPv4 and IPv6 routes

•Metric thresholds of IPv4 and IPv6 routes

You can configure client applications, such virtual router redundancy protocol (VRRP), to receive a notification when the state of a tracked object changes.

This chapter contains the following sections:

•IPv4 Object Tracking Commands

•IPv6 Object Tracking Commands

IPv4 Object Tracking Commands

The following section describes the IPv4 VRRP commands.

debug track

Enables debugging for tracked objects.

Syntax	debug track [all notifications object-id]
Parameters	all	Enables debugging on the state and notifications of all
		tracked objects.
	notifications	Enables debugging on the notifications of all tracked objects.
	object-id	Enables debugging on the state and notifications of the
		specified tracked object. The range is 1 to 500.
Defaults	Enable debugging on the state and notifications of all tracked objects (debug
	track all).

Object Tracking 1039