Dell 9.7(0.0) manual Hello, Seconds

VersionDescription

7.6.1.0Introduced on the C-Series.

7.4.1.0Introduced on the E-Series.

Related	protocol lldp (Configuration) — enables LLDP globally.
Commands
	debug lldp interface — debugs LLDP.
	show lldp neighbors — displays the LLDP neighbors.

hello

Configure the rate at which the LLDP control packets are sent to its peer.

S6000

Syntax	hello seconds
	To revert to the default, use the no hello seconds command.
Parameters	seconds	Enter the rate, in seconds, at which the control packets are

sent to its peer. The rate is from 5 to 180 seconds. The default is 30 seconds.

Defaults

Command Modes

Command History

30 seconds

CONFIGURATION (conf-lldp) and INTERFACE (conf-if-interface-lldp)

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

VersionDescription

9.7(0.0) Introduced on the S6000-ON.

9.0.2.0Introduced on the S6000.

8.3.19.0Introduced on the S4820T.

8.3.11.1Introduced on the Z9000.

8.3.7.0Introduced on the S4810.

7.7.1.0Introduced on the S-Series.

7.6.1.0Introduced on the C-Series.

7.4.1.0Introduced on the E-Series.

Link Layer Discovery Protocol (LLDP) 959