Dell 9.7(0.0) manual Ip igmp snooping mrouter interface interface

Version	Description
7.5.1.0	Introduced on the C-Series.
E-Series legacy
command

Usage	This last-member-query-interval is also the interval between successive Group-
Information	Specific Query messages. To change the last-member-query interval, use this
	command.

ip igmp snooping mrouter

Statically configure a VLAN member port as a multicast router interface.

S6000

Syntax ip igmp snooping mrouter interface interface

Parameters

Defaults

Command Modes

Command History

To delete a specific multicast router interface, use the no igmp snooping mrouter interface interface command.

interface	Enter the following keywords and slot/port or number
interface	information:
	• For a 10-Gigabit Ethernet interface, enter the keyword
	TenGigabitEthernet then the slot/port information.
	• For a 40-Gigabit Ethernet interface, enter the keyword
	fortyGigE then the slot/port information.
	• For a port channel interface, enter the keywords port-
	channel then a number. The range is from 1 to 128.

Not configured.

INTERFACE VLAN — (conf-if-vl-n)

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Version	Description
9.7(0.0)	Introduced on the S6000-ON.
9.5(0.0)	Introduced on the Z9500.
9.2(0.0)	Introduced on the M I/O Aggregator. This command is
	supported in Programmable-Mux (PMUX) mode only.

9.0.2.0Introduced on the S6000.

8.3.19.0Introduced on the S4820T.

Internet Group Management Protocol (IGMP) 659