Parameters

Defaults

Command Modes

Command History

To remove a static IPv6 entry from the IPv6 neighbor discovery, use the no ipv6

neighbor [vrf vrf-name] {ipv6-address} {interface interface}

command.

vrf vrf-name

(Optional) Enter the keyword vrf followed by the name of the

 

VRF to install IPv6 routes in that VRF.

ipv6-address

Enter the IPv6 address of the neighbor in the x:x:x:x::x

 

format.

 

NOTE: The :: notation specifies successive hexadecimal

 

fields of zero.

interface

Enter the keyword interface then the interface type and

interface

slot/port or number information:

 

• For a 10-Gigabit Ethernet interface, enter the keyword

 

TenGigabitEthernet then the slot/port information.

 

• For a 40-Gigabit Ethernet interface, enter the keyword

 

fortyGigE then the slot/port information.

 

• For a Loopback interface, enter the keyword loopback

 

then a number from 0 to 16383.

 

• For a port channel interface, enter the keywords port-

 

channel then a number.

 

• For a Null interface, enter the keyword null then the Null

 

interface number.

 

• For a VLAN interface, enter the keyword vlan then a

 

number from 1 to 4094.

 

• For a tunnel interface, enter the keyword tunnel then

 

the tunnel interface number. The range is from 1 to

 

16383.

hardware_addr

Enter a 48-bit hardware MAC address in nn:nn:nn:nn:nn:nn

ess

format.

none

 

CONFIGURATION

 

This guide is platform-specific. For command information about other platforms,

refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

VersionDescription

9.7(0.0)

Added support for VRF. Introduced on the S6000-ON.

8.3.19.0Introduced on the S4820T.

8.3.11.1Introduced on the Z9000.

Neighbor Discovery Protocol (NDP)

1027

Page 1027
Image 1027
Dell 9.7(0.0) manual Neighbor vrf vrf-name ipv6-address interface interface, Hardwareaddr, Ess