Dell 9.7(0.0) manual Numbers if you are using the range logical operand

Defaults

Command Modes

Command History

port port	Enter the application layer port number. Enter two port
	numbers if you are using the range logical operand. The
	range is from 0 to 65535.
	The following list includes some common TCP port
	numbers:
	•	23 = Telnet
	• 20 and 21 = FTP
	•	25 = SMTP
	•	169 = SNMP
destination	Enter the IP address of the network or host to which the
	packets are sent.
mask	Enter a network mask in /prefix format (/x) or A.B.C.D. The
	mask, when specified in A.B.C.D format, may be either
	contiguous or non-contiguous.
count	(OPTIONAL) Enter the keyword count to count packets the
	filter processes.
byte	(OPTIONAL) Enter the keyword byte to count bytes the filter
	processes.
order	(OPTIONAL) Enter the keyword order to specify the QoS
	priority for the ACL entry. The range is from 0 to 254 (where
	0 is the highest priority and 254 is the lowest; lower-order
	numbers have a higher priority). If you do not use the
	keyword order, the ACLs have the lowest order by default
	(255).
fragments	Enter the keyword fragments to use ACLs to control packet
	fragments.

Not configured.

CONFIGURATION-EXTENDED-ACCESS-LIST

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

VersionDescription

9.7(0.0) Introduced on the S6000–ON.

9.0.2.0Introduced on the S6000.

8.3.19.0Introduced on the S4820T.

8.3.11.1Introduced on the Z9000.

8.3.7.0Introduced on the S4810.

212 Access Control Lists (ACL)