Dell 9.7(0.0) - page 426

Command
History This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Added the ipv4 multicast and ipv6 unicast parameters.
9.4(0.0) Added support for VRF.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.7.1.0 Introduced on the C-Series.
Usage
Information To determine a BGP session flap, both a route-down event and a subsequent
route-up event corresponding to a single route are considered. As a result, a flap
event is penalized only one time during the route-down event. The subsequent
route-up event corresponding to the same route is not considered as a flap and is
not penalized.
The history paths that the show ip bgp command displays contain only the prefix
and the next-hop information. The next-hop information shows the ip address of
the neighbor. It does not show the actual next-hop details.
The following describes the show ip bgp damp command shown in the
following example.
Field Description
Network Displays the network ID to which the route is dampened.
From Displays the IP address of the neighbor advertising the
dampened route.
Reuse Displays the hour:minutes:seconds until the dampened
route is available.
Path Lists all the ASs the dampened route passed through to
reach the destination network.
Example Dell#show ip bgp dampened-paths
BGP local RIB : Routes to be Added 0, Replaced 0, Withdrawn 0
BGP local router ID is 192.168.11.5
Status codes: s suppressed, S stale, d dampened, h history, *
valid, > best
Path source: I - internal, a - aggregate, c - confed-external,
r - redistributed
n - network, D - denied, S - stale
Origin codes: i - IGP, e - EGP, ? - incomplete
426 Border Gateway Protocol