Dell 9.7(0.0) manual Ip split-horizon

Defaults

Command Modes

Command History

Usage Information

Related Commands

2 (OPTIONAL) Enter the number 2 for RIP version 2.

RIPv1

INTERFACE

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

VersionDescription

9.7(0.0) Introduced on the S6000-ON.

9.0.2.0Introduced on the S6000.

8.3.19.0Introduced on the S4820T.

8.3.11.1Introduced on the Z9000.

8.3.7.0Introduced on the S4810.

7.8.1.0Introduced on the S-Series.

7.6.1.0Introduced on the C-Series.

pre- 6.2.1.1 Introduced on the E-Series.

To enable the interface to send both version of RIP packets, use the ip rip send version 1 2 command.

ip rip receive version — sets the RIP version for the interface to receive traffic.

version — sets the RIP version for the switch software.

ip split-horizon

Enable split-horizon for RIP data on the interface. As described in RFC 2453, the split-horizon scheme prevents any routes learned over a specific interface to be sent back out that interface.

S6000

Syntax	ip split-horizon
	To disable split-horizon, use the no ip split-horizoncommand.
Defaults	Enabled
Command	INTERFACE
Modes

1312 Routing Information Protocol (RIP)